![]() ![]() After removing all the glass, it was one big mess of adhesive and baby oil. Slowly the adhesive starts to loose its strength.īecause of the different cracks in the display, the glass was taken off in parts.Īfter a few hours, most of the glass was removed from the LCD panel.īe careful, the broken glass is quite sharp.ĥ. We also used a spudger and a piece of carton to separate the glass and LCD panel. We add a lot of baby oil between the glass and LCD. At the same time we used baby oil to make sure the silicon adhesive was not sticky anymore. We used a piece of plastic (similar to a creditcard) to separate the glass and the LCD. Most likely the polarized filter should be replaced after this removal. It is quite possible to damage the LCD screen. The silicon adhesive appears to be quite strong. Carefully we removed more broken glasses.Ĥ. We started to remove the silicon adhesive with some baby oil. After removing a few broken glasses we can see there is some silicon adhesive between the LCD panel and glass. 27 inch iMac display with broken glass in the corner and cracks in the display.Ģ. This article just only shows how removing the glass would look like.ġ. This display has the glass glued to the screen. We had the chance to experiment on a defective 27 inch iMac display. The silicon adhesive that is used to laminate the glass to the LCD panel is strong and when trying to remove the glass it is most likely you will damage the LCD or polarizer film. ![]() However repairing the display of this new iMac is basically impossible. This helps to minimize reflections from other light sources. The 2012 and newer iMac have their screens glued to the glass. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |